System-Guard Configuration Commands (For S3100; System-Guard Configuration Commands; Display System-Guard Config - H3C s3100 series Command Manual

5
System-Guard Configuration Commands (For
S3100-SI)
The command introduced in this chapter is only supported by the S3100-SI series switches.

System-guard Configuration Commands

display system-guard config

Syntax
display system-guard config
View
Any view
Parameter
None
Description
Use the display system-guard config command to display current system-guard configuration and
the attacked ports.
Example
# Display the information about system-guard.
<Sysname> display system-guard config
state : disable
mode : rate-limit
interval-time : 5
threshold : 64
timeout : 60
permit interfaces :
Ethernet1/0/1
attacked and controled interfaces:
5-1