H3C s3100 series Command Manual page 1024

View
Layer-2 Ethernet interface view
Parameters
None
Description
Use the ipv6 nd detection trust command to configure a port as the ND trusty port. Use the undo ipv6
nd detection trust command to configure a port as the ND untrusty port.
By default, a port is ND untrusty.
Among S3100 series switches, only S3100-EI series switches support the two commands.
Examples
## Configure the Ethernet interface Ethernet1/0/1 on Layer 2 as ND trusty port.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] ipv6 nd detection trust
ipv6 nd snooping enable
Syntax
ipv6 nd snooping enable
undo ipv6 nd snooping enable
View
VLAN view
Parameters
None
Description
Use the ipv6 nd snooping enable command to enable ND snooping.
Use the undo ipv6 nd snooping enable command to restore the default.
By default, ND snooping is disabled.
1-35