H3C s3100 series Command Manual page 959

Parameters
administrator-name: Name of the administrator creating the test.
operation-tag: Test operation tag.
Description
Use the display hwping statistics command to display test statistics.
After a test begins, if all the probes in the first test have not been finished, when you use the command
to view statistics, all statistics results will be 0.
Examples
# Display the statistics information for admin jitter test group, the test type of which is jitter.
<Sysname> display hwping statistics admin jitter
HWPing entry(admin admin, tag jitter) statistics record:
No. :
Destination ip address:
StartTime:
LifeTime:
Send operation times:
Max Round Trip Time:
Sum Round Trip Time:
Square-Sum of Round Trip Time: 0
Disconnect operation number: 0
System busy operation number:0
Operation sequence errors:
Other operation errors:
Jitter result:
Min Positive SD:0
Max Positive SD:0
Positive SD Number:0
Positive SD Sum:0
Positive SD average:0
Positive SD Square Sum:0
Min Negative SD:0
Max Negative SD:0
Negative SD Number:0
Negative SD Sum:0
Negative SD average:0
Negative SD Square Sum:0
SD lost packets number:0
SD packet lost in test:0%
Unknown result lost packet number:0
Table 1-8 Description on fields in the output of the display hwping statistic command
Start time
1
169.254.10.3
2000/1 /2 3 :12:44
21
0
0
0
0
0
Field
Receive response times:
Min Round Trip Time:
Average Round Trip Time:
Packet lost in test:
Operation timeout number: 0
Connection fail number:
Drop operation number:
Min Positive DS:0
Max Positive DS:0
Positive DS Number:0
Positive DS Sum:0
Positive DS average:0
Positive DS Square Sum:0
Min Negative DS:0
Max Negative DS:0
Negative DS Number:0
Negative DS Sum: 0
Negative DS average:0
Negative DS Square Sum:0
DS lost packet number:0
DS packet lost in test:0%
The time when a test starts
1-13
0
0
0
0%
0
0
Description