Ntp-Service Multicast-Client - H3C s3100 series Command Manual

View
System view
Parameter
number: Maximum number of the dynamic NTP sessions that can be established locally. This argument
ranges from 0 to 100.
Description
Use the ntp-service max-dynamic-sessions command to set the maximum number of dynamic NTP
sessions that can be established locally.
Use the undo ntp-service max-dynamic-sessions command to restore the default.
By default, up to 100 dynamic NTP sessions can be established locally.
Example
# Set the maximum number of dynamic NTP sessions that can be established locally to 50.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ntp-service max-dynamic-sessions 50

ntp-service multicast-client

Syntax
ntp-service multicast-client [ ip-address ]
undo ntp-service multicast-client [ ip-address ]
View
VLAN interface view
Parameter
ip-address: Multicast IP address, in the range of 224.0.1.0 to 239.255.255.255. The default IP address
is 224.0.1.1.
Description
Use the ntp-service multicast-client command to configure an Ethernet switch to operate in the NTP
multicast client mode and receive NTP multicast messages through the current interface.
Use the undo ntp-service multicast-client command to remove the configuration.
By default, no NTP operate mode is configured.
Example
# Configure the switch to receive NTP multicast messages through Vlan-interface1, with the multicast
IP address being 224.0.1.2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 1
[Sysname-Vlan-interface1] ntp-service multicast-client 224.0.1.2
1-9