Mld-Snooping Host-Join - H3C s3100 series Command Manual

View
VLAN view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in seconds. The effective range is 200 to 1,000.
Description
Use the mld-snooping host-aging-time command to configure the aging time of dynamic member
ports in the current VLAN.
Use the undo mld-snooping host-aging-time command to restore the system default.
By default, the dynamic member port aging time is 260 seconds.
This command takes effect only if MLD snooping is enabled in the VLAN.
Related commands: mld-snooping enable, host-aging-time.
Examples
# Enable MLD snooping and set the aging time of dynamic member ports to 300 seconds in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping host-aging-time 300

mld-snooping host-join

Syntax
mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
undo mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
View
Ethernet interface view
Default Level
2: System level
Parameters
ipv6-group-address: Address of IPv6 multicast group which the simulated host is to join. The effective
range is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y represent any
hexadecimal number between 0 and F, inclusive.
ipv6-source-address: Address of the IPv6 multicast source that the simulated host is to join.
vlan vlan-id: Specifies a VLAN that comprises the port(s), where vlan-id is in the range of 1 to 4094.
2-14