Table 3-9 Description on the fields of display transceiver manuinfo interface
Field
Manu. Serial Number
Manufacturing Date
Vendor Name
port auto-power-down
Syntax
port auto-power-down
undo port auto-power-down
View
Ethernet port view
Parameters
None
Description
Use the port auto-power-down command to enable auto power down on the 1000 Mbps uplink port.
Use the undo port auto-power-down to restore the default.
By default, auto power down is not enabled on the 1000 Mbps uplink port.
Note that: Currently, the Ethernet switches only support configuring auto power down on 1000 Mbps
uplink ports. If you configure this feature on a 10/100Base-TX autosensing Ethernet port, the system
shows an error prompt: "Error: Operation not supported!"
Examples
# Enable auto power down on GigabitEthernet 1/1/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface gigabitethernet1/1/1
[Sysname-GigabitEthernet1/1/1] port auto-power-down
reboot
Syntax
reboot [ unit unit-id ]
View
User view
Parameter
unit-id: Unit ID of a switch, the value can only be 1.
Serial number generated during debugging and testing
Debugging and testing date.. The date takes the value of the system
clock of the computer that performs debugging and testing.
Vendor name specified, that is, H3C.
3-13
Description