Quit - H3C s3100 series Command Manual

add: Specifies to add a time value based on the universal time coordinated (UTC) time to generate a
later time.
minus: Specifies to subtract a time value based on the UTC time to generate an earlier time.
HH:MM:SS: Time to be added or subtracted from the UTC time, in the form of HH:MM:SS.
Description
Use the clock timezone command to set the local time zone.
Use the undo clock timezone command to restore the local time zone to the default UTC time zone.
After the setting, you can use the display clock command to check the setting. The log information time
and the debugging information time adopts the local time after the time zone and the summer time have
been adjusted.
Related command: clock summer-time, display clock.
Example
# Set the local time zone named z5, which is five hours earlier than the UTC time.
<Sysname> clock timezone z5 add 05:00:00
<Sysname> display clock
05:03:17 z5 Mon 01/01/2001
Time Zone : z5 add 05:00:00
Summer-Time : abc1 one-off 06:00:00 08/01/2005 06:00:00 09/01/2005

quit

Syntax
quit
View
Any view
Parameter
None
Description
Use the quit command to return from current view to a lower level view.
The following lists the three levels of views available on a switch (from lower level to higher level):
User view
System view
VLAN view, Ethernet port view, and so on
If the current view is user view, this command is used to quit the system.
Related command: return, system-view.
Example
# Return from system view to user view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
1-3
01:00:00