Display Acl Remaining Entry - H3C s3100 series Command Manual

Field
3 times matched

display acl remaining entry

Syntax
display acl remaining entry
View
Any view
Parameter
None
Description
Use the display acl remaining entry command to display information about the remaining ACL
resources.
According to the output, you can determine the number of resources consumed by a certain type of ACL
rules and whether the exhaustion of resources causes the failure to assign ACL rules.
Only H3C S3100-EI series switches support this command.
Example
# Display information about the remaining ACL resources.
<Sysname> display acl remaining entry
Resource Total
Type Number
--------------------------------------------------------------------------
Rule
Table 1-2 Description on the fields of the display acl remaining entry command
Field
Resource Type
Total Number
Reserved Number
Configured Number
Number of times that the rule has been matched. Only matches where the
ACL is referenced by upper layer software are counted. Note that this field
is displayed on only S3100-SI series Ethernet switches.
Reserved Configured
Number Number
1024 13
Resource type, Rule: number of rule resources that the switch can
assign
Total number of ACL resources
Number of resources reserved for system ACLs
Number of resources configured for user-defined ACLs
Description
Remaining Start
Number Port Name
1 1010 Eth1/0/1
Description
1-4
End
Port Name
GE1/2/1