H3C s3100 series Command Manual page 1089

[Sysname] lldp hold-multiplier 6
lldp management-address-tlv
Syntax
lldp management-address-tlv [ ip-address ]
undo lldp management-address-tlv
View
Ethernet interface view
Parameters
ip-address: Management address to be set.
Description
Use the lldp management-address-tlv command to enable the management address sending. This
command also sets the management address.
Use the undo lldp management-address-tlv command to disable management address sending.
By default, the management address is sent through LLDPDUs, and the management address is the
primary IP address of the VLAN with the smallest VLAN ID among the VLANs whose packets are
permitted on the port. If the primary IP address is not configured, the management address is 127.0.0.1.
Notes that:
An LLDPDU carries only one management address. If you set the management address
repeatedly, the latest one takes effect.
LLDP encodes management addresses in numeric format in management address TLVs. Make
sure that a neighbor also encodes its management address in numeric format to guarantee normal
communication with the neighbor.
Examples
# Set the management address to 192.6.0.1 for Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp management-address-tlv 192.6.0.1
lldp notification remote-change enable
Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
View
Ethernet interface view
Parameters
None
1-19