Mld-Snooping Query-Interval - H3C s3100 series Command Manual

Default Level
2: System level
Parameters
None
Description
Use the mld-snooping querier command to enable the MLD snooping querier function.
Use the undo mld-snooping querier command to disable the MLD snooping querier function.
By default, the MLD snooping querier function is disabled.
Note that: This command takes effect only if MLD snooping is enabled in the VLAN.
Related commands: mld-snooping enable.
Examples
# Enable MLD snooping and the MLD snooping querier function in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping querier

mld-snooping query-interval

Syntax
mld-snooping query-interval interval
undo mld-snooping query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: MLD query interval in seconds, namely the length of time the device waits between sending
MLD general queries. The effective range is 2 to 300.
Description
Use the mld-snooping query-interval command to configure the MLD query interval.
Use the undo mld-snooping query-interval command to restore the system default.
By default, the MLD query interval is 125 seconds.
This command takes effect only if MLD snooping is enabled in the VLAN.
2-19