H3C s3100 series Command Manual page 882

log: Specifies to output log information.
trap: Specifies to output trap information.
debug: Specifies to output debugging information.
level severity: Specifies an information severity level. For the value of severity, refer to
state state: Configures whether to output the system information. The value of state can be on (enabled)
or off (disabled).
Description
Use the info-center source command to specify the output rules of the system information.
Use the undo info-center source command to remove the specified output rules.
By default, the output rules for the system information are listed in
This command can be used to set the filter and redirection rules of log, trap and debugging information.
For example, the user can set to output log information with severity higher than warnings to the log
host, and information with severity higher than informational to the log buffer. The user can also set to
output trap information of the IP module to a specified output destination.
Note that:
If you do not use the module-name argument to set output rules for a module, the module uses the
default output rules or the output rules set by the default keyword; otherwise, the module uses the
output rules separately set for it.
If you use the module-name argument to set the output rules for a module without specifying the
debug, log, and trap keywords, the default output rules for the module are as follows: the output of
log and trap information is enabled, with severity being informational; the output of debugging
information is disabled, with severity being debugging. For example, if you execute the command
info-center source snmp channel 5, the command is actually equal to the command info-center
source snmp channel 5 debug level debugging state off log level informational state on trap
level informational state on.
After you separately set the output rules for a module, you must use the module-name argument to
modify or remove the rules. The new configuration by using the default keyword is invalid on the
module.
You can configure to output the log, trap and debugging information to the trap buffer, but the trap
buffer only receives the trap information and discards the log and debugging information.
You can configure to output the log, trap and debugging information to the log buffer, but the log
buffer only receives the log and debugging information and discards the trap information.
You can configure to output the log, trap and debugging information to the SNMP module, but the
SNMP module only receives the trap information and discards the log and debugging information.
Table
1-12
Table 1-2.
1-4.