H3C s3100 series Command Manual page 622

Keyword
cs7
ef
Table 1-16 802.1p precedence keywords and the corresponding decimal/binary values
Keyword
best-effort
background
Spare
excellent-effort
controlled-load
Video
Voice
Network-management
exceed exceed-action: Sets the actions on the part of the packets exceeding the specified traffic when
the packet traffic exceeds the specified traffic. The actions include:
drop: Drops the packets.
forward: Forwards the packets.
remark-dscp dscp-value: Resets the DSCP precedence of the packets and forwards them at the
same time. The DSCP value is in the range of 0 to 63. You can also enter a keyword listed in
1-15 for this argument.
meter-statistic: Performs the statistics function on traffic policing. It can meter the bytes of the packets
within the limited rate and the bytes of the packets beyond the limited rate. Note that, for the same ACL
rule, the meter statistic keyword in this command and the traffic accounting function are mutually
exclusive in system view, Ethernet port view, or port group view.
Description
Use the traffic-limit command to perform traffic policing for all the packets matching specific ACL rules,
or for packets that match specific ACL rules and are of a port group or pass a port.
Use the undo traffic-limit command to cancel the configuration.
By default, traffic policing is disabled globally, on all port groups, and all ports.
Only H3C S3100-EI series switches support this command.
With broadcast suppression, multicast suppression, or line rate for the inbound direction enabled
on a device, you cannot configure traffic policing on the device. For detailed information about
broadcast suppression and multicast suppression, refer to Basic Port Configuration in this manual.
DSCP value (decimal)
56
46
802.1p precedence (decimal)
0
1
2
3
4
5
6
7
1-34
DSCP value (binary)
111000
101110
802.1p precedence (binary)
000
001
010
011
100
101
110
111
Table