H3C s3100 series Command Manual page 621

acl-rule: ACL rules to be applied. This argument can be the combination of multiple ACLs. For more
information about this argument, refer to
must be those defined with the permit keyword specified.
target-rate: Target traffic rate of traffic policing ( in kbps). This argument is in the range of 64 to 1000000
in system view and port group view. In Ethernet port view, the range of this argument varies by port type
as follows:
Fast Ethernet port: 64 to 99,968;
GigabitEthernet port: 64 to 1,000,000.
The granularity of port rate limit is 64 Kbps. Assume that the value you provide for the target-rate
argument is in the range N*64 to (N+1)*64 (N is a natural number), it will be rounded off to (N+1)*64.
burst-bucket burst-bucket-size: Specifies the maximum burst traffic size (in kilobytes) allowed. The
burst-bucket-size argument must a multiple of 8 and ranges from 8 to 1016.
conform con-action: Sets the actions of the switch on the packets except forwarding when the packet
traffic is within the specified traffic. The con-action argument can be:
remark-dscp dscp-value: Sets the DSCP precedence for the packets. The dscp-value argument is
in the range of 0 to 63. You can also enter a keyword listed in
remark-cos cos-value : Sets the 802.1p precedence for the packets. The cos-value argument is in
the range of 0 to 7. You can also enter a keyword listed in
Table 1-15 DSCP precedence keywords and the corresponding decimal/binary values
Keyword
af11
af12
af13
af21
af22
af23
af31
af32
af33
af41
af42
af43
be (the default)
cs1
cs2
cs3
cs4
cs5
cs6
Table 1-9 and Table
DSCP value (decimal)
10
12
14
18
20
22
26
28
30
34
36
38
0
8
16
24
32
40
48
1-33
1-10. Note that the ACL rules referenced
Table 1-15 for this argument.
Table 1-16 for this argument.
DSCP value (binary)
001010
001100
001110
010010
010100
010110
011010
011100
011110
100010
100100
100110
000000
001000
010000
011000
100000
101000
110000