H3C s3100 series Command Manual page 916

Receive optical power fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
RX power high
RX power low
Laser bias current fault
Laser temperature fault
Laser output power fault
TX fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
TX bias high
TX bias low
TX power high
TX power low
Temp high
Temp low
Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port configuration
mismatch
Transceiver type not supported by port
hardware
For pluggable transceivers supported by S3100 series Ethernet switches, refer to H3C S3100 Series
Ethernet Switches Installation Manual.
Examples
# Display the alarm information of the transceiver on interface GigabitEthernet 1/1/2.
<Sysname> display transceiver alarm interface gigabitethernet 1/1/2
GigabitEthernet1/1/2 transceiver current alarm information:
TX fault
Field Remarks
Receive optical power fault
PMA/PMD (Physical Medium Attachment/Physical
Medium Dependent) receiver local fault
PCS (Physical Coding Sublayer) receiver local fault
PHY XS (PHY Extended Sublayer) receive local fault
RX power is high.
RX power is low.
Laser bias current fault
Laser temperature fault
Laser output power fault
TX fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
TX bias current is high.
TX bias current is low.
TX power is high.
TX power is low.
Temperature is high.
Temperature is low.
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port configuration.
Transceiver type is not supported on the port.
3-9