Reset Garp Statistics - H3C s3100 series Command Manual

By default, the LeaveAll timer is set to 1,000 centiseconds, that is, 10 seconds.
In networking, you are recommended to set the GARP LeaveAll timer to 12000 centiseconds (2
minutes).
Related commands: display garp timer.
Examples
# Set the GARP LeaveAll timer to 100 centiseconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] garp timer leaveall 100

reset garp statistics

Syntax
reset garp statistics [ interface interface-list ]
View
User view
Parameters
interface-list: Specifies a list of Ethernet ports. In this list, you can specify individual ports and port
ranges. An individual port takes the form of interface-type interface-number and a port range takes the
form of interface-type interface-number1 to interface-type interface-number2, with interface-number2
taking a value greater than interface-number1. The total number of individual ports and port ranges
defined in the list must not exceed 10.
Description
Use the reset garp statistics command to clear the GARP statistics (including statistics about packets
received/sent/discarded by GVRP) on the specified or all ports.
Executing the reset garp statistics command without any parameter clears the GARP statistics of all
ports.
Related commands: display garp statistics.
Examples
# Clear GARP statistics of all ports.
<Sysname> reset garp statistics
1-5