Test-Type - H3C s3100 series Command Manual

Examples
# Set the test to start from 14:03 and last 3600 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] test-time begin 14:03:00 lifetime 3600

test-type

Syntax
test-type type [ codec codec-value ]
View
HWPing test group view
Parameters
type: Test type. It can be any of the following keywords:
dhcp: Indicates a DHCP test.
dns: Indicates a DNS test.
ftp: Indicates an FTP test.
http: Indicates an HTTP test.
icmp: Indicates an ICMP test.
jitter: Analyzes the delay change of UDP packet transmission.
snmpquery: Indicates an SNMP test.
tcpprivate: Indicates a TCP test on a specified (unknown) port.
tcppublic: Indicates a TCP test on port 7.
udpprivate: Indicates a UDP test on a specified (unknown) port.
udppublic: Indicates a UDP test on port 7.
codec-value: Coding type for a voice test, which can be configured for a Jitter test and can be the
following keywords:
g711a: Specifies coding type to G.711 A-Law.
g711u: Specifies coding type to G.711 muHmm-Law.
g729a: Specifies coding type to G.729A-Law.
Description
Use the test-type command to configure the test type.
The default test type is icmp.
If you modify the test type, the parameter configuration, test results and history records of the original
test type will be cleared.
1-34