Nvram Data Upload/Download - Gestetner B070 Service Manual

FIRMWARE UPDATE

5.10.6 NVRAM DATA UPLOAD/DOWNLOAD

Uploading Content of NVRAM to an SD card
Follow this procedure to upload SP code settings from NVRAM to an SD card.
NOTE: This data should always be uploaded to an SD card before the NVRAM is
replaced.
1. Before switching the machine off, execute SP5990 001 (SMC Print). You will
need a record of the NVRAM settings if the upload fails.
2. Switch the copier main power switch off.
3. Insert the SD card into service slot C3, then switch the copier on.
4. Execute SP5824 001 (NVRAM Data Upload) then press the "Execute" key
When uploading is finished, the following files are coped to an NVRAM folder
on the SD card. The fileis saved to the path and filename:
NVRAM\<serial number>.NV
Here is an example with Serial Number "B0700017":
NVRAM\B0700017.NV
5. In order to prevent an error during the download, be sure to mark the SD card
that holds the uploaded data with the number of the machine from which the
data was uploaded.
NOTE: NVRAM data from more than one machine can be uploaded to the
same SD card.
B070/B071
CÓPIA NÃO CONTROLADA
5-114
CÓPIA NÃO CONTROLADA
SM