After Moving The Copier - Gestetner B070 Service Manual

COPIER (B070/B071)

After Moving the Copier

1. Load the toner bottles in the toner bank.
2. Remove the right upper cover.
3. Open the cylinder top cover, clean the inner surface of the cylinder with a cloth,
then close the cover.
4. Execute SP5804 070 (Output Check – Toner Bank Motor) to switch on the
toner supply motor.
5. Execute SP5804 068 (Output Check – Upper Toner Bottle Motor) and SP5804
069 (Output Check – Lower Toner Bottle Motor) to switch on the bottle motors
for about 5 to 6 seconds.
NOTE: To prevent toner overflow in the toner entrance tank, do not execute
these SP commands for longer than 5 to 6 seconds.
6. Execute SP5804 071 (Output Check – Toner Supply Coil Clutch) to switch on
the toner supply coil clutch. 50 to 60 seconds later, toner is supplied to the
toner supply cylinder. Make sure that toner is properly supplied to the cylinder.
7. Execute SP5804 071 and SP5804 070 to switch off the toner supply coil clutch
and toner supply motor.
8. Re-install all removed parts.
9. Move the drum cleaning blade lever down away from the shipping position.
B070/B071
CÓPIA NÃO CONTROLADA
1-26
CÓPIA NÃO CONTROLADA
SM