Gestetner B070 Service Manual page 948

BULLETIN NUMBER:
APPLICABLE MODEL:
GESTETNER – 9002/10512
LANIER - LD 090/LD 0105
RICOH – Aficio 2090/Aficio 2105
SAVIN – 4090/40105
SUBJECT: SC672, SLOW PRINTING SPEED, NETWARE PRINTING ERROR
SYMPTOM:
1. SC672 (controller start-up error)
Note: There are a total of 9 separate causes that can trigger SC672. To cover all possible causes, it is
necessary to modify all the firmware.
2. NetWare printing error
Machine will not accept print jobs after a certain amount have been sent via NetWare.
3. Words missing (French/Spanish)
Some words are not displayed in French (missing from wording lists).
4. Printing speed with Standard TCP/IP Port is too slow
CAUSE:
Firmware.
SOLUTION:
Please perform the firmware upgrade. (Refer to Units Affected table for machine cut-in serial number)
•
Controller: B0705734B: V.1.04.4 or higher
•
NIC: B0705735B: V.4.03 or higher
•
BIOS: B0705742D: K02EL00O or higher
•
LCDC: B0705371B (NA): V.2.07 or higher
Copyright     2003 RICOH Corporation. All rights reserved.
CÓPIA NÃO CONTROLADA
TECHNICAL SERVICE BULLETIN
B070/B071 – 001
CÓPIA NÃO CONTROLADA
04/24/2003
Page 1 of 4