Gestetner B070 Service Manual page 980

Rev. 06/2003
⇒
Please keep the following important points in mind when you are doing this setting:
• Note that the number entries for Keys 1 to 5 are the same for the Copy, Printer,
Scanner, and Web memory modules.
• The initial settings are all zero.
• These settings remain in effect until you change them. Be sure to check all the
settings, especially the settings for Keys 6 to 10. To switch off a key setting,
enter a zero for that key.
• You can select any number of keys from 1 to 10 (or all) by entering the
corresponding 4-digit numbers from the table.
• You cannot mix settings for the groups (COPY, PRINTER, etc.) for 006~010. For
example, if you want to create a PRINTER debug log you must select the
settings from the 9 available selections for the "PRINTER" column only.
• One area of the disk is reserved to store the debug log. The size of this area is
limited to 4 MB.
5.16.2 RETRIEVING THE DEBUG LOG FROM THE HDD
Retrieve the debug log by copying it from the hard disk to an SD card.
1. Insert the SD card into the service slot of the copier.
2. Enter the SP mode and execute SP5857 009 (Copy HDD to SD Card (Latest 4
MB)) to write the debugging data to the SD card.
3. After you return to the service center, use a card reader to copy the file and
send it for analysis to Ricoh by email, or just send the SD card by mail.
5.16.3 RECORDING ERRORS MANUALLY
Since only SC errors and jams are recorded to the debug log automatically, for any
other errors that occur while the customer engineer is not on site, please instruct
customers to perform the following immediately after occurrence to save the debug
data. Such problems would include a controller or panel freeze.
NOTE: In order to use this feature, the customer engineer must have previously
switched on the Save Debug Feature (SP5857-001) and selected the hard
disk as the save destination (SP5857-002).
1. When the error occurs, on the operation panel, press
2. On the control panel, enter "01" then hold down
the machine beeps then release. This saves the debug log to the hard disk for
later retrieval with an SD card by the service representatives.
3. Switch the machine off and on to resume operation.
The debug information for the error is saved on the hard disk so the service
representatives can retrieve it on their next visit by copying it from the HDD to
an SD card.
SM
CÓPIA NÃO CONTROLADA
5-131
CÓPIA NÃO CONTROLADA
USING THE DEBUG LOG
(Clear Modes).
for at least 3 sec. until
B070/B071