Gestetner B070 Service Manual page 401

Rev. 06/2004
SP Number/Name
2909 Main Scan Magnification
001 Copy
002 Printer
2910 Writing Sub Scan Magnification
2911 Transfer Current On / Off Timing
001 La (ON)
002 Lb (Switch)
2911 003 Lc (OFF)
2912 Drum Reverse Rotation Interval
001 1st Reverse Rotation
002 Forward Rotation After 1st Reverse
Rotation
003 2nd Reverse Rotation
2915 Drum Heater Adjustment
001 ON Time at Power On （＜100°C） [0~10 / 0 / 1 min.]
2915 002
ON Time at Power On (＜140°C )
003 Drum Temperature
004 Sensor Output Value (Direct)
005 Sensor Output Value (Atmosphere)
006 Forced Heater ON
2920 LD Off Check
SM
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE TABLES
Adjusts the magnification in the main
scan direction for copy mode. ( 3-17)
[-2.0~+2.0 / 0 / 0.1%]
Use the "
before entering the value.
Adjusts the magnification in the main
scan direction for printing mode. ( 3-17)
[-2.0~+2.0 / 0 / 0.1%]
Use the "
before entering the value.
Adjusts the magnification in the sub scan
direction. ( 3-17)
[-1.0~+1.0 / 0 / 0.1%]
Use the "
before entering the value.
Adjusts the transfer current on timing at
the leading edge.
[-30~+30 / 0 / 1 mm]
Adjusts the transfer current on/off
exchange timing. [0~60 / 45 / 1 mm]
Adjusts the transfer current off timing (for
example: –5 mm is 5 mm after the trailing
edge). [-30~+30 / 0 / 1 mm]
Sets the length of time the drum is
reversed to clean the drum cleaning
blade. [0~7 / 2 / 20 ms]
Sets the length of time the drum is rotated
forward after the 1st reverse rotation.
[0~7 / 0 / 20 ms]
Sets the length of time the drum is
reversed for the 2nd reverse rotation to
clean the drum cleaning blade again.
[0~7 / 0/ 20 ms]
SP 2915 is currently not being used.
Do not change the settings.
DFU
[0~10 / 0 / 1 min.]
DFU
DFU
DFU
DFU
DFU
Checks whether the LD turns off or on
when the front door is opened. DFU
[0~1 / 0 / 0]
0: ON
1: OFF
5-19
CÓPIA NÃO CONTROLADA
Function/[Setting]
•
/ *key to enter the minus ( –)
•
/ *key to enter the minus ( –)
•
/ *key to enter the minus ( –)
B070/B071