Updating The Lcdc For The Operation Panel - Gestetner B070 Service Manual

FIRMWARE UPDATE

5.10.4 UPDATING THE LCDC FOR THE OPERATION PANEL

Follow this procedure to update the LCDC (LCD Control Board).
1. Turn the copier main switch off.
2. Insert the SD card into service slot C3.
3. Switch the copier main switch on.
4. After about 10 seconds the initial screen opens in English.
5. Touch "OpePanel".
6. Touch "UpDate(#) (or
After about 9 seconds, the downloading starts.
While the data is downloading, the operation panel goes off and the main
power on key flashes at 0.5 s intervals. When the update is finished, the same
key starts flashing slower at 3 s intervals.
7. Switch the copier main power switch off, remove the SD card, then switch the
copier on again.
B070/B071
CÓPIA NÃO CONTROLADA
PCcard -> ROM Page01
ROM: G0000000
Printer (1)
ROM: 0.01
ROM: B0705254
Engine (2)
ROM: 2.16:16
OpePanel.DOM (3) ROM: B0705370
ROM: 1.22
Verify(./*)
) to start the update.
5-112
CÓPIA NÃO CONTROLADA
NEW: G0000000
NEW: 0.0X
NEW: B0705254
NEW: 2.16:16
NEW: B0705370
NEW: 2.00
Exit(0) UpDate(#)
SCR03_OPE.WMF
SM