Gestetner B070 Service Manual page 399

Rev. 06/2004
SP Number/Name
Back – On/Off Setting
2602 003
004 Back – On/Off Timing Adj.
Front – On/Off Setting: Low Speed
005
Mode
Front – Off Timing Adj.: Low Speed
006
Mode
Back– On/Off Setting: Low Speed
007
Mode
SM
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE TABLES
Switches the PTL on and off for the back
side of the paper passing through the
fusing unit in the duplex mode at normal
speed.
[0~1/0/1]
0: Off
1: On
Notes:
•
•
This SP adjusts the length of the space
from the leading edge where the PTL
quenching is applied to the back side at
normal speed. For example, if you set +5,
5 mm from the leading edge will be
quenched. [-5~10/2/0.1 mm]
Switches the PTL on and off for the front
side of the paper passing through the
fusing unit at in the low speed mode.
Note: When feeding thick paper or OHP
transparencies, this setting is always off.
[0~1/0/1]
0: Off
1: On
This SP adjusts the length of the space
from the leading edge where the PTL
quenching is applied to the front side in
low speed mode. For example, if you set
+5, 5 mm from the leading edge will be
quenched. [-5~10/2/0.1 mm]
Switches the PTL on and off for the back
side of the paper passing through the
fusing unit in the duplex mode in low
speed mode.
[0~1/0/1]
0: Off
1: On
Notes:
•
•
5-17
CÓPIA NÃO CONTROLADA
Function/[Setting]
When this setting is switched on,
make sure that the setting of SP2940
008 is the same as the default setting
of SP2940 001.
When feeding thick paper or OHP
transparencies, this setting is always
off.
When this setting is switched on,
make sure that the setting of SP2940
016 is the same as the default setting
of SP2940 009.
When feeding thick paper or OHP
transparencies, this setting is always
off.
B070/B071