COVER INTERPOSER TRAY (B470)
Docking the Finisher with the Machine
[D]
[C]
1. Attach the sponge strip [A] provided with the finisher.
NOTE: If you are installing the cover interposer tray with a previously installed
finisher, remove the strip from the finisher and attach it to the cover
interposer tray.
2. Attach the guide plate [B] (removed from the finisher) to the cover interposer (
x 2).
NOTE: Be sure to use the two small tapping screws provided, not the machine
screws removed from the finisher with the guide plate.
3. Release the lock lever [C] ( x 1).
4. Lower the transport guide plate [D].
5. Slowly push the finisher against the side of the machine until the brackets [E]
enter the slots.
CAUTION
Dock the finisher carefully to avoid bending the entrance guide plates.
Bent guide plates could interfere with paper transport from the machine
to the finisher.
6. Secure the lock lever [C] ( x 1).
7. Raise the transport guide plate [D] to close it.
8. Plug the connector [E] into the copier.
9. Switch on the machine and execute SP5158 001 ~ 008 to select the default
paper sizes for the cover interposer unit. For details, see the service manual "5.
Service Tables".
B070/B071
CÓPIA NÃO CONTROLADA
[A]
[B]
1-74
CÓPIA NÃO CONTROLADA
[F]
[E]
B470I005.WMF
SM