Gestetner B070 Service Manual page 421

Rev. 06/2004
SP Number/Name
5802 Printer Free Run
5803 Input Check
5804 Output Check
5811 Machine No. Setting
001 Code Set
5812 Service Tel. No. Setting
001 Service
002 Fax
003 Supply
004 Operation
5816 CSS Function
5821 CSS-PI Device Code
5824 NV-RAM Data Upload
5825 NV-RAM Data Download
5828 Network Setting
012 Device Name/Host Name
066 Job Spooling Clear
069 Job Spooling Protocol
074 Delete Password
084 NCS Prints
SM
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE TABLES
Makes a base engine free run
[0~1/0/1]
0: Release free run mode
1: Enable free run mode
Return this setting to off (0) after testing is
completed.
Finisher connectors should be
disconnected and duplex mode should be
off.
Displays signals received from sensors
and switches. ( 5.4.1)
Turns on the electrical components
individually for testing. ( 5.5.1)
Enters the machine serial number. DFU
Use this to input the telephone number of
the CE (displayed when a service call
condition occurs.)
Press "
modes" to delete the telephone number.
Use this to input the fax number of the CE
printed on the SMC print.
Displayed on the initial SP screen.
Allows the service center contact
telephone number to be displayed on the
initial screen.
Switches the CSS function on/off. Do not
change. Japan Only.
[0~1/0/1]
Do not change. Japan Only.
[0~4/0/1]
Uploads the NVRAM data to a SD card.
( 5.10.6)
Downloads data from the SD card to the
NVRAM in the machine. When
downloading this SP mode data, the front
door must be open.
After downloading is completed, remove
the card and cycle the machine off and on.
( 5.10.6)
Execute to delete network password.
Prints a list of all NCS related parameters.
5-39
CÓPIA NÃO CONTROLADA
Function/[Setting]
・
" to input a pause. Press "Clear
B070/B071