Gestetner B070 Service Manual page 497

Downloading an SD Card to NVRAM
Follow this procedure to download SP data from an SD card to the NVRAM in the
machine.
• If the SD card with the NVRAM data is damaged, or if the connection between
the controller and BCU is defective, the NVRAM data down load may fail.
• If the download fails, repeat the download procedure.
• If the second attempt fails, enter the NVRAM data manually using the SMC print
you created before uploading the NVRAM data. ( 5.10.6)
1. Switch the copier main power switch off.
2. Insert the SD card with the NVRAM data into service slot C3.
3. Switch the copier main power switch on.
4. Execute SP5825 001 (NVRAM Data Download) and press the "Execute" key.
NOTE: In order for the NVRAM data to download successfully, the serial
number of the file on the SD card must match the serial number of the
machine. If the serial numbers do not match, the download will fail.
This procedure downloads the following data to the NVRAM:
• Total Count
• C/O, P/O Count
SM
CÓPIA NÃO CONTROLADA
5-115
CÓPIA NÃO CONTROLADA
FIRMWARE UPDATE
B070/B071