Toner Hopper - Gestetner B070 Service Manual

DEVELOPMENT AND TONER SUPPLY

3.8.9 TONER HOPPER

1. Take out the development unit. (!3.8.1)
2. Replace the toner hopper ( x 2).
NOTE: The new toner hopper has a red gear. This red gear is used for Step 3
only.
3. Execute SP2207 002 (Toner Bank Toner Setup).
NOTE: Occasionally, SP2207 002 finishes within a few seconds. If this occurs,
execute SP2207 002 again. This operation normally continues for
about 5 minutes.
4. Remove the white gear [A] from the old toner hopper.
5. Remove the red gear [B] from the new hopper and replace it with the white
gear from the old toner hopper.
NOTE: The white gear is used for machine operation.
B070/B071
CÓPIA NÃO CONTROLADA
[B]
3-62
CÓPIA NÃO CONTROLADA
[A]
B070R973.WMF
SM