Gestetner B070 Service Manual page 424

SERVICE PROGRAM MODE TABLES
SP
5836 085 Capture Setting: Format for
Binary Print
086 Capture Setting: Format for Dither
Print (1200dpi)
091 Capture Setting: Default for JPEG
(Page Quality)
5839 IEEE 1394
004 Device Name
007 Cycle Master
008 BCR mode
009 IRM 1394a Check
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
5-42
CÓPIA NÃO CONTROLADA
Function/[Setting]
Determines the image format for Binary
Print images sent to the Document Server
via the MLB (Media Link Board).
[0~3/1/1]
0: JFIF/JPEG
2: TIFF/MH
Determines the image format for Dither
Print images sent to the Document Server
via the MLB (Media Link Board).
[0~3/1/1]
0: JFIF/JPEG
2: TIFF/MH
Determines the quality level of JPEG
images sent to the Document Server via
the MLB (Media Link Board).
[5~95/50/1]
This SP is displayed only when an IEEE
1394 card is installed.
Enter the name of the device used on the
network. Example: RNP0000000000
Enables or disables the cycle master
function for the 1394 bus standard.
[0~1/1/1]
0: Disable (Off) 1: Enable (On)
Determines how BCR (Broadcast Channel
Register) operates on the 1394 standard
bus when the independent node is in any
mode other than IRM. (NVRAM: 2-bits)
(Range: Binary settings 0~3)
00: Off. Writes from the IRM.
01: Copies BCR of the IRM after no data is
written from the IRM after the
prescribed time has elapsed.
10: Reserved. Not used.
11: BCR normally enabled.
Conducts a 1394a check of IRM when the
independent node is in any mode other
than IRM. [0~1/0/1]
0: Checks whether IRM conforms to
1394a
1: After IRM is checked, if IRM does not
conform then independent node switches
to IRM.
Rev. 06/2004
1: TIFF/MMR
3: TIFF/MR
1: TIFF/MMR
3: TIFF/MR
SM