Gestetner B070 Service Manual page 112

INSTALLATION OF MFP CONTROLLER OPTIONS
[D]
[B]
4. Remove the cover [A] of Slot B4 ( x 2).
5. Insert the NIC board [B] into Slot B4 and fasten it with the screws.
6. Remove the cover [C] of Slot B2 ( x 2).
7. Insert the Centronics board [D] into Slot B2 and fasten it with the screws.
8. Hold the SD Card [E] with its label facing the as shown above, then insert it into
Slot C1.
NOTE: Pushing in the SD Card releases it for removal. Make sure the SD Card
is inserted and locked in place. If it is partially out of the slot, push it in
gently until it locks in place.
B070/B071
CÓPIA NÃO CONTROLADA
[E]
1-78
CÓPIA NÃO CONTROLADA
[C]
[A]
B580I103.WMF
SM