Gestetner B070 Service Manual page 103

1.11.2 INSTALLATION
This procedure describes installation of the Cover Interposer Tray B470 on the
Booklet Finisher B468, 3000 Sheet Finisher 469, and 3000 Sheet Finisher B478.
• The B468/B469 require installation of only the front spacer.
• The B478 requires installation of corner plates.
Removing Tapes and Retainers
1. If the finisher is connected to the machine, disconnect it.
2. Remove all tape and retainers from the cover interposer tray [A].
3. Remove the tape and cardboard [B] from the ground connector.
4. Remove the cover [C] of the relay connector.
5. Loosen the screw of the bracket [D] ( x 1) then remove the bracket.
NOTE: If you are installing the cover interposer tray with a previously installed
finisher B468/B469/B478, remove the sponge strip [E] from the finisher
and save it for re-attachment to the interposer tray.
6. Remove the guide plate [F].
SM
CÓPIA NÃO CONTROLADA
[A]
[B]
B470I001.WMF
1-69
CÓPIA NÃO CONTROLADA
COVER INTERPOSER TRAY (B470)
[E]
[C]
[D]
[F]
B470I007.WMF
B070/B071