Gestetner B070 Service Manual page 957

COPIER (B070/B071)
⇒
Initializing Developer Supply
1. When the machine is ready, enter SP mode:
1) Press
2) Enter "107".
3) Hold down
2. Press "Copy SP" on the LCD, and perform the TD initial setting:
1) Select SP2801 (TD Sensor Initial Setting)
⇒
2) Use the keys displayed on the screen and the numeric keys on the LCD to
enter the developer Lot No., then press
NOTE: The Lot No. is embossed on the top edge of the developer packet.
3) Press "Execute" on the LCD.
NOTE: This executes the TD initial setting. After about 1 minute, "Completed"
is displayed on the screen, and the execution stops automatically.
3. Start to supply toner from the toner bank to the toner hopper:
1) Select SP2207 002 (Toner Bank Toner Setup).
2) Press the "Start key" on the LCD.
This procedure supplies toner to the toner hopper and the toner transport path.
It will stop automatically in about 7 minutes. If SP2207 002 fails after SP2801 is
completed (an SC code is displayed), repeat only SP2207 002.
4. Execute SP2962 (Auto Process Control Execution).
NOTE: In step 1, if you enter SP mode immediately after switching the
machine on, the system will not execute process control automatically.
To ensure that process control calibrates its settings, use this SP to
execute process control manually.
B070/B071
CÓPIA NÃO CONTROLADA
.
for more than 3 seconds.
CÓPIA NÃO CONTROLADA
.
1-20
Rev. 06/2003
SM