Paper Size Detection Table; Selecting The Paper Size For Undetectable Sizes - Gestetner B070 Service Manual

DETAILS

Paper Size Detection Table

Paper Size
A3 SEF 297 x 420 mm
A4 LEF 297 x 210 mm
DLT SEF 11" x 17"
LT LEF 11" x 8
B4 SEF 257 x 364 mm
B5 LEF 257 x 182 mm
A4 SEF 210 x 297 mm
LT SEF 8
1/2
A5 LEF 210 x 148 mm
HLT LEF 8
1/2
B5 SEF 182 x 257 mm
F SEF 8" x 13"
A5 SEF 148 x 210 mm
HLT SEF 5
1/2
Table Key
The paper size switch consists of 4 feelers that slide along the wiring patterns
of the paper width switch terminal plate when the side fences are manually
1, 2, 3, 4 adjusted to fit the size of the paper loaded in the tray. The H, L status of each
feeler is determined by whether the feeler is in contact with the wire of a
pattern.
H High (5 V) (Inactive)
L Low (0 V) (Active)
The machine determines the paper size automatically by reading the output of
"
the paper size switch and the paper length sensor.
The machine cannot detect the paper size automatically. The user must select
#
the paper size manually before starting the job. See below.

Selecting the Paper Size for Undetectable Sizes

Press the Tray Paper Settings button on the operation panel to select paper sizes
that are not detected automatically by the combination of paper size and paper
length sensor readings (marked "#" in the table above and any other paper size
not listed that requires pulling out the paper tray extension).
NOTE: Mixed paper sizes cannot be loaded into the bypass tray. Loading paper of
different sizes will cause a paper jam.
B512
CÓPIA NÃO CONTROLADA
Paper Size SN
1
H
H
"
1/2
H
" x 11"
H
" x 5 "
1/2
H
L
" x 8 " L
1/2
CÓPIA NÃO CONTROLADA
Length
Sensor
2 3 4
H H L
H L L
H L H
L L H
L H H
L H H
H H H
22
Area
Europe
NA
/Asia
"
L
"
H
"
L
H "
"
L
"
H
#
L
"
#
H
"
#
L
"
"
H
"
H
"
"
"
"
"
"
"
#
"
#
#
"
"
"
SM