Gestetner B070 Service Manual page 375

• Documents stored on the document server, included scanned documents,
will not be lost.
• The first time the network accesses the machine, the management
information must be reconfigured (this will require a significant amount of
time).
Before initializing the Netfile partition with SP5823 011, do the following:
1. Enter the User Tools mode and execute "Delivery Settings" to print all received
fax documents scheduled for delivery and delete them.
2. In the User Tools mode, execute Document Management> Batch Delete
Transfer Documents.
3. Execute SP5832 011 then cycle the machine off and on.
Procedure 3
If "Procedure 2" does not solve the problem, execute SP5832 001 (HDD
Formatting – All), then cycle the machine off and on.
Executing SP5832 001 erases all document and address book data stored on the
hard disks. Be sure to consult with the customer before executing this SP code.
Procedure 4
If "Procedure 4" fails to correct the problem, replace the HDDs.
SC951: F-GATE Signal Error
Definition [B]
When the IPU has already received the F-GATE signal (laser writing start trigger
signal), the IPU receives another F-GATE signal.
Possible Causes
• Software defective; switch off/on, or change the BCU firmware if this does not
solve the problem
• BCU defective
SC953: Scanner Image Setting Error
Definition [B]
The settings required for image processing using the scanner are not sent from the
IPU.
Possible Causes
• Check the connections between the MCU and LCDC and BCU
• Replace the MCU, BCU, or IPU
• Change the BCU or MCU firmware
SM
CÓPIA NÃO CONTROLADA
4-55
CÓPIA NÃO CONTROLADA
SERVICE CALL CONDITIONS
B070/B071