Gestetner B070 Service Manual page 139

Rev. 01/2004
⇒
CAUTION
All anti-condensation heaters are disconnected from the AC drive board
before shipping. Before plugging in the AC harness connector, make sure
that the main switch of the copier is switched off and the power cord is
unplugged.
Note 1: The connector is hung on the clamp under the AC drive board.
Note 2: The tray heater is ON when the machine is in Auto Off Mode. (Main or
operation SW is OFF)
Fig.1
If you want the tray heater ON for 24 hours, disconnect the relay connector and set
the anti-condensation heater connector as shown Fig.2
CAUTION
At this time, the heater is always ON when the power plug is connected
with the power source. Use caution when you perform machine
maintenance.
SM
CÓPIA NÃO CONTROLADA
Fig.2
1-105
CÓPIA NÃO CONTROLADA
TRAY HEATER KITS
B070/B071