Gestetner B070 Service Manual page 394

SERVICE PROGRAM MODE TABLES
SP
2114 Printer Dot Edge Parameter Setting
001
002
003
004
005
006
007
008
2115 Main Scan Beam Pitch Adjustment
001
002
003
004
005
006
⇒
007
2201 Development Bias Adjustment
001
002
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
Leading Dot Level Setting
Trailing Dot Level Setting
Multiple Dot Level Setting
Independent Dot Level Setting
(1200 dpi)
Leading Dot Level Setting
Trailing Dot Level Setting
Multiple Dot Level Setting
Independent Dot Level Setting
dpi)
Pitch Adjustment Between LD0 and
LD2 (LD0)
Pitch Adjustment Between LD0 and
LD4 (LD0)
Pitch Adjustment Between LD0 and
LD6 (LD0)
Pitch Adjustment Between LD1 and
LD3 (LD1)
Pitch Adjustment Between LD1 and
LD5 (LD1)
Pitch Adjustment Between LD1 and
LD7 (LD1)
Pitch Adjustment Between CH0 and
CH1
Image Area
ID Sensor Pattern
(Auto Process Control OFF)
CÓPIA NÃO CONTROLADA
Allows setting a parameter for binary
edge processing for the printer
application with FCI switched off. This SP
allows adjustment of image quality if the
desired effect cannot be achieved with
the default settings for edge processing.
In general, increasing the values
produces thicker lines and decreasing
them produces thinner lines. However,
some settings could cause defective
images on white paper.
[2~8 / 5/ 1]
(1200 dpi)
[2~8 / 5/ 1]
(1200 dpi)
[2~8 / 8 / 1]
(1200 dpi)
[2~8 / 6/ 1]
[2~16 / 12/ 1]
(600 dpi)
[2~16 / 12/ 1]
(600 dpi)
[2~16 / 16/ 1]
(600 dpi)
[2~16 / 12/ 1]
(600
A label attached to the LD unit service
part lists the correct settings.
[-100~100 / 0 / 1 µm]
[-100~100 / 0 / 1 µm]
[-100~100 / 0 / 1 µm]
[-100~100 / 0 / 1 µm]
[-100~100 / 0 / 1 µm]
[-100~100 / 0 / 1 µm]
[-100~100 / 0 / 1 µm]
Adjusts the development bias for copying.
[-200~-800 / -550 / 10 V]
This can be adjusted as a temporary
measure if faint copies appear due to an
aging drum.
Adjusts the development bias for making
the ID sensor pattern for VSP
measurement when the auto process
control is set to off.
[-200~-800 / -400 / 10 V]
This should not be used in the field,
because it affects ID sensor pattern
density, which affects toner supply.
5-12
Rev. 06/2004
Function/[Setting]
SM