1.8.2 INSTALLATION PROCEDURE
B377I201.WMF
[D]
B377I202.WMF
CAUTION
Switch off the main machine and unplug its power cord.
1. If the finisher is connected to the machine, disconnect it.
2. Unpack the punch unit and remove all tapes and shipping retainers.
3. Open the front door and remove the rear cover [A] ( x 4).
4. Remove the bracket [B] ( x 2) and paper guide [C] ( x 1).
5. Remove the plastic knockout [D].
6. Install the sensor bracket arm [E] ( x 1).
NOTE: Make sure that the sensor arm swings freely on the step screw.
7. Install the spring [F].
SM
CÓPIA NÃO CONTROLADA
[A]
[C]
[E]
[F]
1-59
CÓPIA NÃO CONTROLADA
PUNCH UNIT (B377)
[B]
B377I103.WMF
B070/B071