Gestetner B070 Service Manual page 490

FIRMWARE UPDATE
Firmware Update Error
If a firmware update error occurs, this means the update was cancelled during
the update because the module selected for update was not on the SD card.
⇒
⇒
Clearing E32 and E44 Codes
Clear E32 and E44 codes with the following procedure and then re-istall the
firmware again:
1. Press
appear.
2. Press ("Clear" key) three times.
C
The machine will indicate the error has been cleared with a beep.
Recovery After Power Loss
If the ROM update is interrupted as a result of accidental loss of power while the
firmware is updating, then the correct operation of the machine cannot be
guaranteed after the machine is switched on again. If the ROM update does not
complete successfully for any reason, then in order to ensure the correct operation
of the machine, the ROM update error will continue to be displayed until the ROM
is updated successfully.
In this case, just insert the card once again and switch on the machine to continue
the firmware download automatically from the card without the menu display.
B070/B071
CÓPIA NÃO CONTROLADA
PCcard -> ROM
Data incorrect after download interrupted.
("1", "4", "3" key) on the operation panel when the error codes
CÓPIA NÃO CONTROLADA
E32
5-108
Rev. 05/2004
SCR14.WMF
SM