Gestetner B070 Service Manual page 407

Rev. 06/2004
SP
3902 008 V M700
009 VD Correction
010 VL (Auto Process Control)
011 VL Correction (Auto Process
Control)
012 VL
013 VL Correction
014 VB
⇒
3903 VD Correction Counter
SP4-nnn Scanner
SP
4008 Scanner Sub Scan Magnification
SM
CÓPIA NÃO CONTROLADA
Number/Name
Number/Name
5-25
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE TABLES
Function/[Setting]
Displays the acquired value when the
potential sensor is calibrated after
application of
-700V.
Determines whether VD correction is
performed. DFU
[0~1 / 0/ 1]
0: No Correction. Correction with value of
SP2001 007 only
1: Correction with value of SP2001 007 +
50V
Displays the value of VL at auto process
control initialization.
Displays the amount of correction (∆VLref)
according to results of the VL detection at
auto process control.
Displays the latest value of VL.
Displays the amount of correction (∆VLref)
according to the latest VL detection results.
Displays the value of the current image
development bias output, determined by the
results of VL detection.
Adjusts the starting point for the VD
Correction. Displays whether the VD
correction is being performed. The target
value for VD correction is "the value of SP2-
001-7 + 50".
[0~999 / 200 / 1 K copies]
The counter is automatically reset to 0
(zero) when SP2-801 is performed.
Function/[Setting]
Adjusts the magnification in the sub scan
direction for scanning. If this value is
changed, the scanner motor speed is
changed. ( 3-17)
[-0.9~+0.9 / 0 / 0.1 percent]
•
Use the " / *key to enter the minus ( –)
before entering the value.
Setting a lower value reduces the motor
speed and lengthens the image in the sub
scan direction (paper direction). Setting a
larger value increases the motor speed
and shortens the image in the sub scan
direction.
B070/B071