Gestetner B070 Service Manual page 287

20. Screw [A] securing the toner recycling and collection casing [B].
21. Lift the toner recycling and collection casing [B], pull out the pin [C] from the
hole under the case, then pull out the toner bank unit.
NOTE: When pulling out the toner bank unit, toner may leak out of the junction
between the tube and toner bank. Place a cloth on the machine bottom
plate so that the plate does not become dirty.
After Re-installing the Toner Bank Unit
1. Remove the plastic bag from the toner transport coil tube. Re-connect the toner
supply cylinder to the toner transport coil tube ( x 2, tubes x 3).
2. Load the toner bottles into the toner bank.
3. Open the cylinder top cover and clean the inner surface of the cylinder with a
cloth, then close the cylinder top cover.
4. Execute SP5804 070 to energize the toner bank motor.
5. Execute SP5804 068, 069 to energize the toner bottle motors for 5 to 6
seconds.
6. Execute SP5804 071 to energize the toner supply coil clutch.
7. About 50 to 60 seconds later, toner is supplied to the toner supply cylinder.
Make sure that toner is properly supplied to the cylinder.
8. Turn off the toner supply coil clutch and then the toner bank motor.
NOTE: To prevent overflow at the toner entrance tank, do not energize the toner
bottle motors for a long time.
SM
CÓPIA NÃO CONTROLADA
[A]
3-129
CÓPIA NÃO CONTROLADA
TONER BANK
[C]
[B]
B070R909.WMF
B070/B071