Gestetner B070 Service Manual page 392

SERVICE PROGRAM MODE TABLES
SP
2001 009 Grid Voltage in ID Sensor Pattern
(Auto Process Control off/Low
Speed)
010 Grid Voltage Correction in Auto
Process Control
(Low Speed)
011 Grid Voltage for Transparencies
(Low Speed)
012 Total Corona Current
(Low Speed)
013 Total Corona Current for Photo
Mode
(Low Speed)
2101 Printing Erase Margin
001 Leading Edge
002 Trailing Edge
003 Left edge
004 Right edge
2103 LD Power Adjustment
2104 LD Power Adjustment (for ID Sensor
Pattern)
001 Normal Speed
002 Low Speed
2105 LD Power Correction
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
5-10
CÓPIA NÃO CONTROLADA
Function/[Setting]
Adjusts the voltage applied to the grid
plate when making the ID sensor pattern,
when auto process control is switched off
and the machine is in the low speed
mode.
[-600~-1300 / -710 / 10 V]
Adjusts the voltage applied to the grid
plate when auto process control is on and
the machine is in the low speed mode.
[0~300 / 110 / 10 V] (B070)
[0~300 / 160 / 10 V] (B071)
In low speed mode, this value is
subtracted from the setting of SP2001
003. For example, if SP2001 003 is set at
1000 and this SP is set at 90, then the
value is set at 910 (1000 – 90 = 910).
Adjusts the voltage applied to the grid
plate when Transparency mode is
selected and the machine is in the low
speed mode.
[-600~-1300 / -710 / 10 V]
Adjusts the current applied to the charge
corona wire when the machine is in the
low speed mode (but not the Photo
Mode).
[-1000~-2800 / -1400 / 10 uA]
Adjusts the current applied to the charge
corona wire for Photo mode and low
speed mode.
[-1000~-2800 / -1600 / 10 uA]
( 3-17)
Adjusts the leading edge erase margin.
[0~9.0/ 3.5 / 0.1 mm]
Adjusts the trailing edge erase margin.
[0~9.0/ 2.5 / 0.1 mm]
Adjusts the left side erase margin.
[0~9.0/ 2.0 / 0.1 mm]
Adjusts the right side erase margin.
[0~9.0/ 2.0 / 0.1 mm]
DFU
Selects the LD power for making the ID
pattern when auto process control is
switched on.
DFU
[0~15 / 4 / 1]
DFU
[0~15 / 3 / 1]
This SP mode corrects the banding
caused by: 1) changes in drum
characteristics over time, and 2) LD
power fluctuations. ( 3-17)
Rev. 06/2004
SM