Gestetner B070 Service Manual page 396

SERVICE PROGRAM MODE TABLES
SP
2207 002 Toner Bank Toner Setup
2208 Toner Supply Mode
2209 Toner Supply Rate
001 Normal Speed
002 Low Speed
2210 ID Sensor Pattern Interval
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
5-14
CÓPIA NÃO CONTROLADA
Function/[Setting]
Turns on the drum motor, development
motor, development bias, toner supply
motor and charge corona. Then turns on
the toner supply coil clutch to supply
toner to the toner hopper, but not to the
development unit. Requires about 7
minutes. Remove the white gear from the
toner hopper and install the red gear.
Press Start. Install the white gear again
after finishing with this SP mode.
Use this SP to fill the toner transport path
with toner after cleaning the toner supply
unit, or at installation.
Selects the toner supply mode: Sensor
Control or Image Pixel Count.
[0~1 / 0 / 1]
0: Sensor Control
1: Pixel Count
Select Image Pixel Count only if the TD
sensor has failed and cannot be replaced
immediately, so that the customer can
use the machine. Return the setting to
Sensor Control after replacing the sensor.
Adjust the toner supply amount from the
hopper for the normal operation.
B070: [100~2000 / 850 / 10 mg/s]
B071: [100~2000 / 1000 / 10 mg/s]
Increasing this value reduces the toner
supply roller clutch on time. Use a lower
value if the user tends to make lots of
copies that have a high proportion of
black.
Allows adjustment of the toner supply
amount
from the hopper for low speed mode.
B070: [100~2000 / 850 / 10 mg/s]
B071: [100~2000 / 1000 / 10 mg/s]
Changes the interval for making the ID
sensor pattern (VSP/VSG detection).
[1~500 / 10 / 1 copy]
If the user normally makes copies with a
high proportion of black, reduce the
interval.
Rev. 06/2004
SM