Gestetner B070 Service Manual page 388

SERVICE PROGRAM MODE TABLES
SP
1105 006 Fusing Temperature Correction
(Translucent Sheets)
007 Fusing Lamp Switching at Warm-
up
008 Fusing Temperature Adjustment in
Lower Power Mode
009 Fusing Idling Start Temperature
010 Paper Size Selection for
Temperature Correction
011 Fusing Lamp Switching after Low
Power Mode
1106 Fusing Temperature Display
1107 Fusing Idling Time Setting
1108 Fusing Adjustment before Ready Condition
001 Waiting Condition Time Setting
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
5-6
CÓPIA NÃO CONTROLADA
Function/[Setting]
Specifies the amount to raise or lower
fusing temperature from standby mode to
print on Translucent Sheets (tracing
paper).
B070: [-10~+5 / +2 / 1 deg]
B071: [-10~+5 / +5 / 1 deg]
Specifies the fusing temperature when
switching from 3 fusing lamps on to 2
fusing lamps on to stabilize the fusing
temperature from warm-up. (The fusing
lamp that heats the center of the hot
roller is turned off.)
[20~140 / 40 / 1°C]
Sets the target temperature for the hot
roller when the machine enters low
power mode.
B070: [101~178/ 143 / 1°C]
B071: [101~178/ 150 / 1°C]
Sets the start temperature for fusing
idling. [100~160 / 150 / 1°C]
Determines which threshold paper width
is used for SP1105 003 and SP1105 004.
[0~1 / 0 / 1]
0: LT/A4 LEF
1: 257 mm wide (B5 SEF).
Specifies the fusing temperature to
switch from 3 fusing lamps on to 2 fusing
lamps on when the machine returns from
low power mode:
SP1105-1 – SP1105 011 = Actual Temp.
[5~20 / 10 / 1°C]
The third lamp is not switched on to
prevent overshooting the target
temperature.
Displays the fusing temperature.
Sets the fusing idling time.
[0~60 / 10 / 1 s]
Specifies the length of time to elapse
after the target temperature has been
reached in order to apply even heat
across the length of the hot roller. Only
applies when fusing idling is used.
[0~180 / 80 / 1s]
This SP attempts to reduce the amount
of paper wrinkling, especially if the first
job is on A3 paper after the machine is
started up at the beginning of the
workday.
Rev. 06/2004
SM