Gestetner B070 Service Manual page 991

Tech Service Bulletin No. B070/B071 – 005
5852 continued
006 SMTP Auth. Encryption
007 POP before SMTP
008 POP Server Name
009 POP Port Number
010 POP User Name
011 POP Password
012 POP Auth. Encryption
013 Time out Setting for POP
Procedure for Firmware Update and Manual Input of New SP Defaults
After updating the firmware, it is necessary to manually set some of the new SP modes to their new defaults.
This is necessary not only to enable SMTP authentication, but also to prevent errors that can occur with the
Scan to e-mail function while the values above are still at "0".
CÓPIA NÃO CONTROLADA
Sets encryption method for the transfer
password in SMTP validation.
[0~2 / 0 / 1]
0: Auto. Allows three methods for
1: Off. Allows two methods for SMTP
2: On. Allows only one method for
A flag that determines whether the POP
server is connected before connecting to
the SMTP server.
[0~1 / 0 / 1]
POP
0: OFF
1: On
Post Office Protocol (POP) servers are
computers that receive mail using SMTP.
The mail includes a setting to ensure that it
is directed to the POP server. POP servers
are used when the user is not permanently
connected to the Internet.
Sets the POP server name.
Sets the POP port number.
[1 65535/110/1]
Sets the POP user name.
Sets the POP password.
Sets the encryption method for the
password when 5852 POP Before SMTP
is in use.
[0~2 / 0 / 1]
0: Auto. Allows two methods for
1: Off. Allows only normal encryption.
2: On. Allows only APOP encryption.
Sets the wait time after POP validation
until the SMTP mail is sent.
[0~10000/ 300 /1 ms]
CÓPIA NÃO CONTROLADA
encryption in SMTP validation:
LOGIN, PLAIN, or CRAM-MD5.
validation: LOGIN, PLAIN.
SMTP validation: CRAM-MD5.
encryption: APOP and normal
encryption to match the settings of
the POP server.
Page 3 of 4