Gestetner B070 Service Manual page 205

4. Install the new cleaning blade.
NOTE: 1) To avoid damaging the edge of the blade and causing black lines on
copies, never clean the blade with a cloth.
2) Never touch the edge of a new cleaning blade.
3) If setting powder or toner on the blade edge is removed at any point, re-
apply toner or setting powder at that point. When installing the cleaning
blade, do not pinch the side seals.
Vacuum Cleaning
To protect the electrical parts from static electricity, disconnect the connector on
the charge power pack and remove the ID sensor.
1. Disconnect the 12-pin connector [A].
2. Separate the upper and lower drum units.
3. Remove the spur bracket [B] and pick-off pawl bracket [C] ( x 2).
4. Disconnect the connector [D].
5. Slide the pick-off pawl bracket to the rear, while turning it counterclockwise (as
seen from the front). The ID sensor is on this bracket.
6. After installing a new ID sensor, do SP3001 002 (ID Sensor Settings – ID
Sensor Initialization).
SM
CÓPIA NÃO CONTROLADA
[B]
[C]
3-47
CÓPIA NÃO CONTROLADA
[D]
[A]
B070R559.WMF
DRUM UNIT
B070/B071