Gestetner B070 Service Manual page 310

COPY IMAGE ADJUSTMENT: PRINTING/SCANNING
[A]
[B]
B070R104.WMF
6. Make a note of the position of the laser unit using the scale [A].
7. Adjust the laser unit position using a flat screwdriver [B] as shown.
If the right side of the trimming area pattern is down by about 1 mm as shown
[C], the laser unit should be rotated about one graduation in the direction of the
black arrow. If the opposite side is down, adjust in the opposite direction.
8. Tighten the three screws to secure the laser unit.
9. Print the trimming area pattern to check the image. If it is still the same, repeat
steps 2 to 7.
B070/B071
CÓPIA NÃO CONTROLADA
[C]
3-152
CÓPIA NÃO CONTROLADA
1 mm
Feed Direction
B070R591.WMF
SM