Gestetner B070 Service Manual page 418

SERVICE PROGRAM MODE TABLES
SP
5162 Application Screen Change
5212 Page Numbering
003 Duplex Printout Right / Left
Position
004 Duplex Printout High / Low
Position
5302 Set Time
002 Time Difference
5404 User Code Count Clear
5501 PM Alarm Interval
5504 Jam Alarm Interval
5505 Error Alarm
5507 Supply Alarm
001
002
003
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
Paper
Supply
Alarm
Staple
Supply
Alarm
Toner
Supply
Alarm
5-36
CÓPIA NÃO CONTROLADA
Function/[Setting]
Determines whether the application screen
is changed with a hard switch (key top) or
a soft switch on the LCD.
[0~1 / 0 / 1]
0: Soft switch
1: Hard switch
Horizontally positions the page numbers
printed on both sides during duplexing.
[-10~+10 / 0 / 1 mm]
0: Center
-: Left
+: Right
Vertically positions the page numbers
printed on both sides during duplexing.
[–10~+10/0/1 mm]
0 is center, minus is down, + is up.
Sets the time clock for the local time.
[–1440~+1440/+540/1 min.]
Clears all user code counters.
Press # to execute.
Sets the count level for the PM alarm.
[0~9999 / 0 / 1]
0: Alarm disabled
The PM alarm goes off when the print
count reaches this value multiplied by
1,000.
RDS function Japan Only
RDS function Japan Only
Enables or disables the paper supply call
function. Japan Only
[0~1/0/1]
0: No call
1: Call
If this SP is enabled, use the settings
below to set the supply level to initiate a
call for each paper size.
Enables or disables the staple supply call
function. Japan Only
[0~1/0/1]
0: No call
1: Call
A staple supply call is issued for every
1,000 staples consumed.
Enables or disables the toner supply call
function. Japan Only
[0~1/0/1]
0: No call
1: Call
Rev. 06/2004
SM