Updating Firmware - Gestetner B070 Service Manual

5.10.2 UPDATING FIRMWARE

1. On the machine, switch off the main
power switch.
2. With the label on the SD card [A] facing
as shown in the diagram, insert the SD
card into service slot C3 [B] on the right
side of the controller box [C]. Slowly
push the SD card once into the slot so
it locks in place.
3. Make sure the SD card is locked in
place.
NOTE: To remove the SD, push it in to
unlock the spring lock and then
release it so it pops out of the
slot.
4. If the machine is connected to a network, disconnect the network cable from
the copier.
5. Switch the main power switch on. After about 10 seconds, the initial version
update screen appears on the LCD in English.
KEY
Firmware (1)
Language Data (2)
Exit (0)
SM
CÓPIA NÃO CONTROLADA
[C]
Update Menu
Firmware (1)
Language Data(2)
Press this button on the touch-screen (or
the firmware update screen.
Press this button on the touch-screen (or
the language update screen.
Press this key on the touch-screen (or
update procedure and return to normal machine operation.
5-103
CÓPIA NÃO CONTROLADA
FIRMWARE UPDATE
Exit(0)
SCR01.WMF
WHAT IT DOES
on the 10-key pad) to open
on the 10-key pad) to open
on the 10-key pad) to quit the
[A]
[B]
B580I112.WMF
B070/B071