Gestetner B070 Service Manual page 436

SERVICE PROGRAM MODE TABLES
SP
6120 Staple Jogger Adjustment
001 A3 (Lengthwise)
002 B4 (Lengthwise)
003 A4 (Lengthwise)
004 A4 (Sideways)
005 B5 (Lengthwise)
006 B5 (Sideways)
007 DLT (Lengthwise)
008 LG (Lengthwise)
009 LT SEF (Lengthwise)
010 LT LEF (Sideways)
011 Other
6112 Z – Fold Position Adjustment
Fine Adjustment – 1st Fold Position
001 A3 – 1st Fold Position
002 B4 – 1st Fold Position
003 A4 – 1st Fold Position
004 DLT – 1st Fold Position
005 LG – 1st Fold Position
006 LT – 1st Fold Position
007 12x18 – 1st Fold Position
008 Others – 1st Fold Position
Fine Adjustment – 2nd Fold Position
009 A3 – 2nd Fold Position
010 B4 – 2nd Fold Position
011 A4 – 2nd Fold Position
012 DLT – 2nd Fold Position
013 LG – 2nd Fold Position
014 LT – 2nd Fold Position
015 12x18 – 2nd Fold Position
016 Others – 2nd Fold Position
6121 Staple Jogging Repeat Setting
6902 Fold Position Adjustment
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
CÓPIA NÃO CONTROLADA
Function/[Setting]
Adjusts the staple jogger positions for each
paper size. The higher the setting, the
narrower the jogger span.
[-1.5~+1.5 / 0 / 0.5 mm]
Firmware requirements
The following firmware combinations are
Required to activate the SP modes:
•
BCU (B0705254A) 4.01.1 or later
•
GW (B0705754A) 3.04.1 or later
•
EP-ROM (B4685132 or later)
Adjusts the position of
the first fold [A] to
decrease or increase
the distance (A)
between the leading
edge [B] and the crease
of the 2nd fold [C].
[-4 ~ +4 / 0 / 0.2 mm]
Adjusts the position of
the 2nd fold [C] to
decrease or increase
the length (L1) of the
sheet between the
trailing edge [D] and the
2nd fold.
[-4 ~ +4 / 0 / 0.2 mm]
Determines whether jogging is executed
once or twice for each sheet.
[1~2 / 1 / 1] 1: Once 2: Twice
This SP applies to the B478 finisher only.
Use the 10-key pad to adjust the staple
position in center folding.
[-3.5~+3.5 / 0 / 0.5 mm]
•
Use the " /*" key to toggle between + and –
.
A larger value decreases the length of
trailing edges, a smaller value increases
the length of trailing edges.
5-54
Rev. 6/2004
SM