Gestetner B070 Service Manual page 389

Rev. 06/2004
SP Number/Name
1108 002 Temperature Correction
1109 Fusing Nip Band Check
1902 Web Motor Control
001 Web Consumption
002 Web Motor Drive Interval
003 Web Motor Drive Time
004 Web Near End Setting
005 Web Motor Drive Interval (Low
Speed)
1903 Web Drive Time
001 Web Total Time Display (x 200ms)
002 Web Actual Time Display (x
100ms)
SM
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE TABLES
Corrects the fusing temperature before
reaching standby temperature in order to
prevent overshooting standby
temperature. DFU
[-10~-5 / -8 / 1°C]
Use OHP to execute this SP and feed 1
sheet between the hot roller and
pressure roller where it remains for 30 s
and is then fed out so you can measure
the nip band width.
[OFF, ON]
Displays how much of the web has been
used, expressed as a percentage of the
roll consumed. Switch the machine off/on
after changing this setting.
[0~107 / 0 / 1%]
When you install a partially used roll from
another machine, read this SP before
removal, then input that value with this
SP on the next machine. Otherwise, the
machine has no way of knowing how
much of the partially used roll has been
consumed.
Determines how often the web motor
turns on.
B070
EUR/A: [3~130 / 12.6 / 0.1 sec]
NA:
B071
EUR/A: [3~130 / 10.4 / 0.1 sec]
NA:
Changes the time that the web motor is
driven.
[0.3~3.5 / 2.8 / 0.1 s]
Changes the web consumption ratio at
which web near end is displayed.
EUR/A: [0~100 / 86 / 1%]
NA: [0~100 / 90 / 1%]
Determines how often the web motor
turns on in Low Speed mode.
EUR/A: [3~130 / 15.4 / 0.1 s]
NA:
Displays the total amount of time
(seconds) elapsed during web roll feed.
Displays the total amount of web roll
motor operation time (seconds) for
feeding the current web roll.
5-7
CÓPIA NÃO CONTROLADA
Function/[Setting]
[3~130 / 20.7 / 0.1 sec]
[3~130 / 17.0 / 0.1 sec]
[3~130 / 25.3 / 0.1 s]
B070/B071