Gestetner B070 Service Manual page 432

SERVICE PROGRAM MODE TABLES
SP
5858 Debug Save When
001
002
003
004
5859 Debug Save Key No.
001 Key 1
002 Key 2
003 Key 3
004 Key 4
005 Key 5
006 Key 6
007 Key 7
008 Key 8
009 Key 9
010 Key 10
5907 Plug & Play Maker/Model Name
5913 002 Switchover Permission Time/
Print Application
5914 001 Application Counter DIsplay
003 Copy Counter
5915 Mechanical Counter Detection
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
Engine SC Error
Controller SC Error
Any SC Error
Jam
CÓPIA NÃO CONTROLADA
Function/[Setting]
These SPs select the content of the
debugging information to be saved to the
destination selected by SP5857 002
Stores SC codes generated by copier
engine errors
Stores SC codes generated by GW
controller errors
Stores one SC specified by number.
[0~65535 / 0 / 1]
Refer to Section 4 for a list of SC error
codes.
Stores jam errors
These SP's allow you to set up to 10 keys
for log files for functions that use common
memory on the controller board.
[-9999999~+9999999 / 0 / 1]
Selects the brand name and the production
name for Windows Plug & Play. This
information is stored in the NVRAM. If the
NVRAM is defective, these names should
be registered again.
After selecting, press the "Original Type"
key and "#" key at the same time. When
the setting is completed, the beeper
sounds five times.
Sets the amount of time to elapse while the
machine is in standby mode (and the
operation panel keys have not been used)
before another application can gain control
of the display.
[3~30 / 3 / 1 s]
Printer Counter
0: Off
1: On
Displays whether the mechanical counter
is installed in the machine.
[0~2]
0: Not detected
1: Detected
2: Unknown
5-50
Rev. 06/2004
SM